ECM REMOVAL

PROCEDURE

  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  4. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    1. A205516

      Detach the wire harness clamp from the air cleaner case.

    2. Remove the 3 bolts and air cleaner case.

  8. REMOVE NO. 1 AIR CLEANER INLET

    1. Remove the clip.

    2. A212595

      Detach the 2 claws and remove the No. 1 air cleaner inlet.

  9. DISCONNECT NO. 2 AIR CLEANER INLET

    1. A212594

      Remove the bolt and disconnect the No. 2 air cleaner inlet from the vehicle body.

  10. REMOVE ECM

    1. A340642

      Detach the wire harness clamp.

    2. Raise the 2 levers while pushing the locks on the levers and disconnect the 2 ECM connectors.

      Note:

      After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    3. A344362

      Remove the 2 bolts and ECM.

    4. A344363

      Remove the 2 screws and No. 1 ECM bracket.

    5. A344364

      Remove the 2 screws and No. 2 ECM bracket.