WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Smart Entry and Start System) PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    Lane Departure Alert System (w/ Steering Control)

    Click here

    Parking Assist Monitor System
    Pre-collision System

  2. PRECAUTIONS WHEN USING GTS


    1. When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Smart Key(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  3. PRECAUTION FOR REGISTRATION


    1. Before replacing the door control transmitter module set sub-assembly, refer to Service Bulletin.

  4. PRECAUTIONS FOR DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    1. The door control transmitter module set sub-assembly is a precision instrument. Be sure to observe the following:


      1. Do not subject the door control transmitter module set sub-assembly to strong physical shocks.

      2. Do not keep the door control transmitter module set sub-assembly in a high temperature area for a long time.

      3. Do not use an ultrasonic washing machine to clean the door control transmitter module set sub-assembly.

      4. Do not use the door control transmitter module set sub-assembly near any magnets or magnetized items.

      5. Do not place the door control transmitter module set sub-assembly near magnetic equipment, such as digital audio players, induction cookers, medical devices that generate low-frequency electromagnetic waves, etc.

      6. Do not attach any stickers to the door control transmitter module set sub-assembly.

      7. Do not disassemble the door control transmitter module set sub-assembly.

  5. NOTICE WHEN CHECKING FOLLOWING


    1. Wireless door lock/unlock function:

      This wireless door lock control function operates only when the following 3 conditions are met:


      1. There is no key in the ignition key cylinder.

      2. All doors are closed.

      3. The power door lock control system is operating properly.

        Tech Tips

        The unlock function operates even when a door is open.

    2. The size of the wireless door lock control operation area differs depending on the situation.


      1. The size of the operation area differs depending on the user and the way the door control transmitter module set sub-assembly is held.

      2. In certain areas, the wireless door lock control function will only operate partially for the operation area, which will be reduced due to the vehicle body shape and the influence of the surrounding environment.

      3. Since the door control transmitter module set sub-assembly uses weak radio waves, strong radio waves or electrical noise in the frequency used by the door control transmitter module set sub-assembly may reduce the size of the operation area and the wireless door lock control may not function.

      4. When the transmitter battery is weak, the size of the operation area is reduced and the wireless door lock control may not function.

        Tech Tips

        If the door control transmitter module set sub-assembly has been left in a place that is exposed to direct sunlight, such as on the instrument panel, it may cause the battery to be weakened or cause other related problems.