PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  4. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A01HJT1

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

  5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the connector from the park/neutral position switch assembly.

    2. A01HFCK

      Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.

    3. A01HF5B

      Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly and automatic transaxle assembly.

      Note

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the transmission control shaft lever. Be sure to remove the park/neutral position switch assembly straight along the transmission control shaft lever while being careful not to deform the plate spring that supports the transmission control shaft lever. If the plate spring is deformed, the park/neutral position switch assembly cannot be reinstalled correctly.