FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

  • Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

  • If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

Tip:

  • Use the same procedure for the driver side of RHD and LHD vehicles.

  • The procedures listed below are for the driver side of LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

    1. for Single Type:

      CAUTION:

      • The nuts must not be reused.

      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

      1. Install the front seat airbag assembly LH with 2 new nuts.

        5.5 N*m

        56 kgf*cm

        49 in.*lbf

      2. Attach the 2 clamps to the front seatback frame sub-assembly.

    2. for Dual Type:

      CAUTION:

      • The nuts must not be reused.

      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

      1. Install the front seat airbag assembly LH with 2 new nuts.

        5.5 N*m

        56 kgf*cm

        49 in.*lbf

      2. Attach the 2 clamps to the front seatback frame sub-assembly.

  2. INSTALL SEPARATE TYPE FRONT SEATBACK PAD

    Click hereClick here

  3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER

    Click hereClick here

  4. INSTALL FRONT SEAT HEADREST SUPPORT

    Click hereClick here

  5. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click hereClick here

  6. INSTALL FRONT INNER SEAT CUSHION SHIELD LH

    Click hereClick here

  7. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click hereClick here

  8. INSTALL VERTICAL ADJUSTING HANDLE LH

    Click hereClick here

  9. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH

    Click hereClick here

  10. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  11. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  12. INSTALL BATTERY SERVICE COVER

    Click here

  13. INSTALL DECK BOARD ASSEMBLY

    Click here

  14. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  15. CHECK SRS WARNING LIGHT

    Click here