INPUT SHAFT INSPECTION

PROCEDURE

  1. INSPECT INPUT SHAFT

    1. C113554

      Check the input shaft for wear and damage.

    2. Using a dial indicator, measure the input shaft runout.

      Maximum Runout

      0.03 mm (0.00118 in.)

      If the runout exceeds the maximum, replace the input shaft.

    3. C112446N01

      Using a micrometer, measure the outer diameter of the input shaft journal surface.

      Standard

      Measured Part

      Outer Diameter mm (in.)

      A

      30.008 to 30.020 (1.1814 to 1.1819)

      B

      32.002 to 32.018 (1.2599 to 1.2605)

      If the outer diameter is below the minimum, replace the input shaft.