GENERATOR(for 90A Type) REASSEMBLY

PROCEDURE

  1. INSTALL GENERATOR WITH CLUTCH PULLEY

    1. A333488C01

      *a

      8 mm Hexagon Wrench

      Set SST and an 8 mm hexagon wrench as shown in the illustration.

      09820-30010

    2. Secure the generator assembly in a vise between aluminum plates.

    3. A207657C03

      *a

      Hold

      *b

      Turn

      *c

      8 mm Hexagon Wrench

      While holding SST in place, rotate the 8 mm hexagon wrench counterclockwise, and install the generator with clutch pulley

      80 N*m

      816 kgf*cm

      59 ft.*lbf

      Note:

      Check that the drive end frame is secured in the vise tightly.

  2. INSTALL GENERATOR PULLEY CAP

    1. Install a new generator pulley cap to the generator with clutch pulley.