AIR FUEL RATIO SENSOR(for Sensor 1) INSTALLATION

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

   Tech Tips

   Perform "Inspection After Repair" after replacing the air fuel ratio sensor (sensor 1).

   Click here

   
   
   1. 

      *a	Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

      SST

      09224-00012

      Torque:

      Specified tightening torque

      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)):

        39 N*m (398 kgf*cm, 29 ft.*lbf)

   2. Connect the air fuel ratio sensor connector.

   3. Engage the wire harness clamp.

2. INSTALL DASH PANEL HEAT INSULATOR (for LHD)

   Click here

3. INSTALL DASH PANEL HEAT INSULATOR (for RHD)

   Click here

4. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

5. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)

   Click here

6. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

   Click here

7. INSTALL COWL BODY MOUNTING REINFORCEMENT RH

   Click here

8. INSTALL COWL BODY MOUNTING REINFORCEMENT LH

   Click here

9. INSTALL WATER GUARD PLATE LH

   Click here

10. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

11. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

12. INSPECT FOR EXHAUST GAS LEAK

    Click here

13. PERFORM INITIALIZATION

    
    

    1. Perform "Inspection After Repair" after replacing the air fuel ratio sensor (sensor 1).

       Click here