СИСТЕМА SFI, Diagnostic DTC:P0604/89, P0606/89, P0607/89, P060A, P060D, P060E, P0657/89

DTC Code DTC Name
P0604/89 Internal Control Module Random Access Memory (RAM) Error
P0606/89 ECM / PCM Processor
P0607/89 Control Module Performance
P060A Internal Control Module Monitoring Processor Performance
P060D Internal Control Module Accelerator Pedal Position Performance
P060E Internal Control Module Throttle Position Performance
P0657/89 Actuator Supply Voltage Circuit / Open

DESCRIPTION

The ECM continuously monitors its own internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check insures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.

The ECM memory status is diagnosed by internal mirroring of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The two CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the two CPUs are different or deviate from the standard, 2) the signals sent to the throttle actuator deviate from the standard, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.

DTC No. DTC Detection Condition Suspected Area

P0604/89

P0606/89

P0607/89

P060A

P060D

P060E

P0657/89

ECM internal error

(1 trip detection logic)

 ECM

INSPECTION PROCEDURE

Tech Tips

Read freeze frame data using the intelligent tester. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ OUTPUT DTC


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch ON and turn the tester ON.

    3. Clear the DTCs.

    4. Turn the ignition switch off and turn the tester off.

    5. Disconnect the tester.

    6. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    7. Connect the cable to the negative (-) battery terminal.

    8. Connect the tester to the DLC3.

    9. Turn the ignition switch ON and turn the tester ON.

    10. Enter the following menus: Powertrain / Engine and ECT / DTC.

    11. Read the DTCs.

      Result
      Result Proceed to
      DTCs P0604/89, P0606/89, P0607/89, P060A, P060D, P060E and/or P0657/89 are output A
      DTC is not output B

    B

    CHECK FOR INTERMITTENT PROBLEMS

    A

    REPLACE ECM