REAR DOOR BELT MOULDING(for Hatchback, Wagon) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

    1. Resin Type:

      1. B329865

        Engage the 6 claws to install the rear door belt moulding assembly.

    2. Plating Type:

      1. B334552

        Engage the 5 claws to install the rear door belt moulding assembly.

  2. INSTALL REAR DOOR GLASS RUN

    Click hereClick here

  3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click hereClick here

  4. INSTALL REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

    Click hereClick here

  5. CONNECT REAR DOOR GLASS RUN

    Click hereClick here

  6. CONNECT REAR DOOR WEATHERSTRIP

    1. Engage the clip and connect the rear door weatherstrip.

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click hereClick here

  8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click hereClick here

  9. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click hereClick here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click hereClick here

  11. INSTALL REAR ARMREST ASSEMBLY (w/o Power Window)

    Click hereClick here

  12. INSTALL REAR ARMREST ASSEMBLY (w/ Power Window)

    Click hereClick here

  13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Power Window)

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  14. INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Power Window)

    Click here

  15. INSPECT POWER WINDOW OPERATION (w/ Power Window)

    Click here