PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Click here

  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  3. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A004JF3

      Remove the clip and pin the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.

  4. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH


    1. A004KO1

      Remove the nut, spring washer and the transmission control shaft lever RH.

  5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the park/neutral position switch connector.

    2. A004JH1

      Using a screwdriver, bend the tabs of the lock washer.

    3. A004JEL

      Remove the nut and the lock washer from the park/neutral position switch assembly.

    4. A004KOL

      Remove the bolt and the park/neutral position switch assembly.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.