HAZARD WARNING SWITCH INSPECTION

PROCEDURE

1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for LHD)

   1. 

      *a	Component without harness connected (Hazard Warning Signal Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      4 (TB) - 1 (E)	Hazard warning signal switch off	10 kΩ or higher
      	Hazard warning signal switch on	Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch assembly.

   2. Illumination Inspection

      1. Apply battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

         OK

         Condition	Specified Condition
         Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 2 (ILL-)	Illuminates

         If the result is not as specified, replace the hazard warning signal switch assembly.

2. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY (for RHD)

   1. 

      *a	Component without harness connected (Hazard Warning Signal Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      4 (TB) - 1 (E)	Hazard warning signal switch off	10 kΩ or higher
      	Hazard warning signal switch on	Below 1 Ω

      If the result is not as specified, replace the hazard warning signal switch assembly.

   2. Illumination Inspection

      1. Apply battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

         OK

         Condition	Specified Condition
         Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 2 (ILL-)	Illuminates

         If the result is not as specified, replace the hazard warning signal switch assembly.