GENERATOR(for 90A Type) DISASSEMBLY

PROCEDURE

  1. REMOVE GENERATOR PULLEY CAP

    1. A207655C01

      *1

      Generator Pulley Cap

      Using a screwdriver, remove the generator pulley cap.

  2. REMOVE GENERATOR WITH CLUTCH PULLEY

    1. A333488C01

      *a

      8 mm Hexagon Wrench

      Set SST and an 8 mm hexagon wrench as shown in the illustration.

      09820-30010

    2. Secure the generator assembly in a vise between aluminum plates.

    3. A207656C03

      *a

      Hold

      *b

      Turn

      *c

      8 mm Hexagon Wrench

      While holding SST in place, rotate the 8 mm hexagon wrench clockwise, and remove the generator with clutch pulley.

      Note:

      Check that the drive end frame is secured in the vise tightly.