GLOW PLUG(w/ Glow Plug Controller) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. WARM UP ENGINE

    Note:

    The glow plug assembly may be damaged if it is removed before the engine is warmed up.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR

    1. A356260

      Disconnect the No. 1 glow plug connector connector.

    2. Disengage the clamp.

    3. A350460

      Remove the 4 glow plug screw grommets from the glow plug assemblies.

    4. A350461

      Remove the 4 nuts and No. 1 glow plug connector from the glow plug assemblies.

  6. REMOVE GLOW PLUG ASSEMBLY

    1. A350463

      Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

      Note:

      Do not remove the glow plug assemblies before the engine is warmed up.