STEERING ANGLE SENSOR INSTALLATION

PROCEDURE

1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   1. Install the spiral with sensor cable sub-assembly (Click here).

      Note:

      • Do not replace the spiral cable with the battery connected and the engine switch on.

      • Do not rotate the spiral cable with the battery connected and the engine switch on.

      • Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.

      • Do not remove the steering angle sensor from the spiral cable.

2. INSTALL STEERING COLUMN UPPER COVER

   Click here

3. INSTALL STEERING COLUMN LOWER COVER

   Click here

4. ADJUST SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   Click here

5. INSTALL STEERING WHEEL ASSEMBLY

   1. Install the steering wheel assembly (Click here).

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

7. CHECK SRS WARNING LIGHT

   1. Check the SRS warning light (Click here).