REAR AIRBAG SENSOR(for 5 Door) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click hereClick here

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  4. DISCONNECT NO. 1 REAR SEAT OUTER BELT ASSEMBLY

    Click here

  5. REMOVE REAR SEAT SIDE GARNISH

    Click here

  6. REMOVE SIDE NO. 2 AIRBAG SENSOR ASSEMBLY

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the connector from the side No. 2 airbag sensor assembly.

      Note:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

        C195226C18

        *a

        White Housing Lock

        *b

        Yellow CPA

        *c

        Slide

        *d

        Push

      2. Push down the white housing lock again and disconnect the connector.

        Note:

        Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. B369896

      Remove the nut and side No. 2 airbag sensor assembly from the vehicle body.

      Note:

      Loosen the nut while holding the side No. 2 airbag sensor assembly because the side No. 2 airbag sensor assembly pin (stopper) is easily damaged.

    5. After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      B296256C01

      *a

      Correct

      *b

      Incorrect