FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

3. REMOVE FRONT DOOR SCUFF PLATE

   for Hatchback:

   Click hereClick here

   for Wagon:

   Click hereClick here

   for Sedan:

   Click hereClick hereClick here

4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

   1. Disconnect the front door opening trim weatherstrip.

5. REMOVE REAR DOOR SCUFF PLATE

   for Hatchback:

   Click hereClick here

   for Wagon:

   Click hereClick here

   for Sedan:

   Click hereClick hereClick here

6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

   1. Disconnect the rear door opening trim weatherstrip.

7. REMOVE LAP BELT OUTER ANCHOR COVER

   1. 

      Disengage the 3 claws and remove the lap belt outer anchor cover.

8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

   1. 

      Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.

9. REMOVE CENTER PILLAR LOWER GARNISH

   for Hatchback:

   Click hereClick here

   for Wagon:

   Click hereClick here

   for Sedan:

   Click hereClick hereClick here

10. REMOVE CENTER PILLAR GARNISH ASSEMBLY (for Hatchback, Wagon)

    for Hatchback:

    Click hereClick here

    for Wagon:

    Click hereClick here

11. REMOVE CENTER PILLAR UPPER GARNISH (for Sedan)

    Click hereClick hereClick here

12. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

    1. 

       Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. 

       *a	Protective Tape
       *b	Locking Button
       *c	Release

       Using a screwdriver, pull out the locking button in the direction indicated by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

       Tip:

       Tape the screwdriver tip before use.

    3. 

       Remove the 2 bolts and front seat outer belt assembly.

13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

    1. 

       Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.