TIRE AND WHEEL SYSTEM INSPECTION

PROCEDURE

  1. INSPECT TIRES

    1. Inspect the tires for wear and proper inflation pressure.

      Cold Tire Inflation Pressure

      Tire Size

      Cold Tire Inflation Pressure

      Front

      Rear

      165/65R14 79T

      230 kPa (2.3 kgf/cm2, 33 psi)*1

      220 kPa (2.2 kgf/cm2, 32 psi)*2

      230 kPa (2.3 kgf/cm2, 33 psi)*1

      220 kPa (2.2 kgf/cm2, 32 psi)*2

      165/60R15 77H

      230 kPa (2.3 kgf/cm2, 33 psi)

      240 kPa (2.4 kgf/cm2, 35 psi)

      230 kPa (2.3 kgf/cm2, 33 psi)

      *1: except Rough Road Package

      *2: for Rough Road Package

      Note:

      For 165/60R15 77H tires, there are 2 different tire pressure values. Refer to the tire pressure information label on the vehicle.

    2. C137874

      Using a dial indicator, check the runout of the tires.

      Maximum Tire Runout

      1.4 mm (0.0551 in.)

  2. ROTATE TIRES

    1. Remove the wheel assembly.

      Click here

    2. C163156C03
      V100135

      Front

      Rotate the tires as shown in the illustration.

    3. Install the wheel assembly.

      Click here

  3. INSPECT AND ADJUST WHEEL BALANCE

    1. Inspect and adjust the off-the-car balance.

      1. for Steel Wheel:

        Maximum Imbalance

        8.0 g (0.0176 lb)

        Tip:

        Use clip-on type balance weights for both the inner and outer side.

      2. C144018C01

        *a

        25 mm (0.984 in.)

        except Steel Wheel:

        Maximum Imbalance

        8.0 g (0.0176 lb)

        Note:

        • Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

        • Do not touch the adhesive surface of the balance weight.

        • Adhere a stick-on type balance weight to the flat surface*a shown in the illustration.

        • Push the balance weight with your finger to securely adhere it to the desired position.

        • Do not reuse balance weights.

        Tip:

        Use clip-on type balance weights for the inner side, and stick-on type balance weights for the outer side.

  4. INSPECT FRONT AXLE HUB BEARING

    Click here

  5. INSPECT REAR AXLE HUB BEARING

    Click here