ENGINE UNIT COMPONENTS
ILLUSTRATION
*1 |
FUEL DELIVERY PIPE |
*2 |
INJECTOR VIBRATION INSULATOR |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
ENGINE OIL LEVEL DIPSTICK GUIDE |
*2 |
ENGINE OIL LEVEL DIPSTICK |
*3 |
WATER BY-PASS HOSE ASSEMBLY |
*4 |
O-RING |
*5 |
OIL LEVEL GAUGE GUIDE OIL HOSE |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
EXHAUST MANIFOLD (TWC: Catalyst) |
*2 |
MANIFOLD STAY |
*3 |
NO. 1 IGNITION COIL |
*4 |
EXHAUST MANIFOLD TO HEAD GASKET |
*5 |
INLET EGR GASKET |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
WATER BY-PASS PIPE |
*2 |
WATER BY-PASS PIPE GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
 |
Water |
- |
- |
ILLUSTRATION
*1 |
CAMSHAFT POSITION SENSOR (for Intake Side) |
*2 |
CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side) |
*3 |
CRANKSHAFT POSITION SENSOR |
*4 |
ENGINE COOLANT TEMPERATURE SENSOR |
*5 |
SPARK PLUG |
*6 |
GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
ENGINE OIL PRESSURE SWITCH ASSEMBLY |
*2 |
KNOCK CONTROL SENSOR |
*3 |
OIL CONTROL VALVE FILTER |
*4 |
OIL FILLER CAP SUB-ASSEMBLY |
*5 |
HEAD TAPER SCREW PLUG |
*6 |
OIL FILLER CAP GASKET |
*7 |
GASKET |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
Adhesive 1324 |
★ |
Precoated part |
ILLUSTRATION
*1 |
CYLINDER HEAD COVER GASKET |
*2 |
CYLINDER HEAD COVER SUB-ASSEMBLY |
*3 |
GROMMET |
*4 |
PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY) |
*5 |
THERMOSTAT |
*6 |
VENTILATION SYSTEM GROMMET |
*7 |
WATER INLET |
*8 |
GASKET |
*9 |
VENTILATION HOSE |
*10 |
CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side) |
*11 |
CAMSHAFT POSITION SENSOR (for Exhaust Side) |
*12 |
WIRE HARNESS CLAMP BRACKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
NO. 1 OIL PAN BAFFLE PLATE |
*2 |
NO. 2 OIL PAN SUB-ASSEMBLY |
*3 |
OIL PAN DRAIN PLUG |
*4 |
OIL PAN SUB-ASSEMBLY |
*5 |
OIL STRAINER SUB-ASSEMBLY |
*6 |
RING PIN |
*7 |
OIL STRAINER GASKET |
*8 |
OIL PAN DRAIN PLUG GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
CRANKSHAFT PULLEY |
*2 |
CYLINDER BLOCK DRAIN COCK PLUG |
*3 |
ENGINE WATER PUMP ASSEMBLY |
*4 |
OIL FILTER BRACKET |
*5 |
STUD BOLT |
*6 |
TIMING GEAR COVER TIGHT PLUG |
*7 |
TIMING CHAIN COVER OIL SEAL |
*8 |
TIMING CHAIN COVER SUB-ASSEMBLY |
*9 |
VENTILATION CASE SUB-ASSEMBLY |
*10 |
OIL PUMP GASKET |
*11 |
OIL FILTER BRACKET GASKET |
*12 |
GASKET |
*13 |
WATER PUMP GASKET |
*14 |
OIL FILTER SUB-ASSEMBLY |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
Engine oil |
 |
Adhesive 1324 |
★ |
Precoated part |
- |
- |
ILLUSTRATION
*1 |
CHAIN SUB-ASSEMBLY |
*2 |
CRANKSHAFT STRAIGHT PIN |
*3 |
CRANKSHAFT TIMING SPROCKET |
*4 |
NO. 1 CHAIN TENSIONER ASSEMBLY |
*5 |
REAR ENGINE OIL SEAL |
*6 |
REAR ENGINE OIL SEAL RETAINER |
*7 |
STUD BOLT |
*8 |
TIMING CHAIN GUIDE |
*9 |
TIMING CHAIN TENSION ARM |
*10 |
CHAIN TENSIONER GASKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
|
Engine oil |
- |
- |
ILLUSTRATION
*1 |
CAMSHAFT |
*2 |
NO. 1 CAMSHAFT BEARING CAP |
*3 |
NO. 2 CAMSHAFT BEARING CAP |
*4 |
CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY |
*5 |
CAMSHAFT TIMING SPROCKET ASSEMBLY |
*6 |
CYLINDER BLOCK WATER JACKET SPACER RH |
*7 |
CYLINDER HEAD GASKET |
*8 |
CYLINDER HEAD SUB-ASSEMBLY |
*9 |
NO. 2 CAMSHAFT |
*10 |
VALVE LIFTER |
*11 |
PLATE WASHER |
*12 |
CYLINDER HEAD SET BOLT |
*13 |
CAMSHAFT BEARING CAP OIL HOLE GASKET |
*14 |
NO. 3 CAMSHAFT BEARING CAP |
*15 |
BRACKET |
*16 |
OIL CONTROL VALVE FILTER |
*17 |
CYLINDER BLOCK WATER JACKET SPACER LH |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
*T1 |
1st: 32 N*m (326 kgf*cm, 24 ft.*lbf) 2nd: Turn 180° |
- |
- |