| DTC Code | DTC Name |
|---|---|
| C1AAA | FCM Destination Information Uninitialized |
DESCRIPTION
When the lane departure warning camera is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). If the lane departure warning camera cannot store the country specification information, DTC C1AAA is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1AAA | While the power switch is on (IG), the lane departure warning camera cannot store the country specification information. |
|
CAUTION / NOTICE / HINT
Note
When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed Click here.
When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.
The lane departure alert system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshooting the lane departure alert system after confirming that the communication systems are functioning properly.
PROCEDURE
READ VALUE USING GTS (DESTINATION INFORMATION)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Lane Departure Alert / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Destination Information | Status of the country/JPN, NA, EURO, CHINA or OTHER (GEN-EXP) | Actual country code | - |
| Result | ||||||
|---|---|---|---|---|---|---|
|
| B |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here |
| A |
|
CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)
Clear the DTCs Click here.
Make sure that the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs Click here.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
USE SIMULATION METHOD TO CHECK Click here |
| B |
|
REPLACE LANE DEPARTURE WARNING CAMERA
Replace the lane departure warning camera with a new one Click here.
Perform the lane departure warning camera adjustment Click here.
| NEXT |
|
CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)
Clear the DTCs Click here.
Make sure that the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs Click here.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
END (LANE DEPARTURE WARNING CAMERA WAS DEFECTIVE) |
| B |
|
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
Replace the main body ECU (multiplex network body ECU) with a new one Click here.
| NEXT |
|
CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)
Clear the DTCs Click here.
Make sure that the DTC detection conditions are met.
Tech Tips
If the detection conditions are not met, the system cannot detect the malfunction.
Check for DTCs Click here.
| Result | ||||||
|---|---|---|---|---|---|---|
|
| A |
|
END (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) WAS DEFECTIVE)) |
| B |
|
REPLACE LANE DEPARTURE WARNING CAMERA Click here |