LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Power Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  6. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    1. A004O66

      Disconnect the connector.

    2. A004O8D

      Remove the separate type front seatback pad.

  8. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. A004R3Y

      Disconnect the connector.

    2. A004QIW

      Detach the 8 hooks and remove the seatback spring.

    3. A004NFYE01
      Text in Illustration
      *1 Back Sheet

      Pull the wire harness and disconnect it from the 2 back sheets as shown in the illustration.

    4. A004T64E02
      Text in Illustration
      *1 Back Sheet
      *2 Hook A
      *3 Hook B
      *4 Cable Tie

      Detach the 4 hooks A and fold back the 2 back sheets.

    5. Cut off the 2 cable ties, detach the 2 hooks B, and then remove the lumbar support adjuster assembly LH from the seatback spring.