OIL PUMP REASSEMBLY

PROCEDURE

  1. INSTALL FRONT OIL PUMP OIL SEAL

    1. C138515N01

      Coat the lip of a new front oil pump oil seal with a small amount of MP grease.

    2. Using SST and a hammer, install the front oil pump oil seal to the front oil pump body sub-assembly.

      09350-32014

      09351-32140

      Note:

      The seal end should be level with the outer edge of the front oil pump body sub-assembly.

  2. INSTALL FRONT OIL PUMP BODY O-RING

    1. C138278

      Coat a new front oil pump body O-ring with ATF and install it to the front oil pump body sub-assembly.

      Note:

      Ensure that the O-ring is not twisted.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR

    1. C138277

      Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly with the marked side up.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR

    1. C138276

      Coat the front oil pump drive gear with ATF, and install it to the front oil pump body sub-assembly with the marked side up.

  5. INSTALL STATOR SHAFT ASSEMBLY

    1. C138275N02

      Align each knock pin of the stator shaft assembly with the holes in the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly with the 16 bolts.

      Table 1. Bolt Length

      Bolt

      Length

      A

      14 mm (0.551 in.)

      B

      26 mm (1.02 in.)

    2. Using a T30 "TORX" socket wrench, tighten the 16 bolts.

      9.3 N*m

      95 kgf*cm

      82 in.*lbf

  6. INSPECT OIL PUMP ASSEMBLY

    Click here