AIR CONDITIONING PANEL (for Automatic Air Conditioning System) REMOVAL

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.


  1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. for Manual Air Conditioning System:


      1. A01DVOWE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 10 claws and 4 clips.

      3. A01E1XL

        Detach the 4 claws and disconnect the air conditioner control.

      4. Disconnect the connectors and remove the center instrument cluster finish panel.

    2. for Automatic Air Conditioning System:


      1. A01DYRHE01
        Text in Illustration
        *1 Protective Tape

        Put protective tape around the center instrument cluster finish panel.

      2. Using a moulding remover, detach the 8 claws and 4 clips.

      3. Disconnect the connectors and remove the center instrument cluster finish panel.

  2. REMOVE INTEGRATION PANEL SUB-ASSEMBLY


    1. A01DXLS

      Remove the 4 screws.

    2. A01DWPG

      Remove the 4 screws.

    3. Detach the 3 claws and disconnect the lower heater control base.

    4. A01DY1G

      Disconnect the No. 1 cooler wire from the integration panel sub-assembly (air conditioning panel) as shown in the illustration.

      Note

      Before performing the procedure above, the hazard switch must be turned off. If the switch is on while the base is removed, damage will occur to the switch.