ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B0084QH

      Disconnect the engine coolant temperature sensor connector.

    2. B0083HFN01

      Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

      SST
      09817-33191

      Note

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.