HEIGHT CONTROL WAY INSTALLATION

PROCEDURE


  1. INSTALL HEIGHT CONTROL WAY


    1. B006G3ZC01
      *1 No. 8 Height Control Tube
      *2 Rear No. 8 Height Control Tube

      Connect the No. 8 height control tube and rear No. 8 height control tube.

      Click here

      Note


      • Connect the height control tube uniformly in alphabetical order.

      • Replace the O ring, plate and No. 2 connector with new ones.

    2. B006GKB

      Install the height control way with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    3. Connect the connector.

  2. CHECK CONNECTIONS OF TUBES FOR AIR LEAKAGE


    1. Install the front wheel RH.

      Click here

    2. Check the connections of the tubes for air leakage.

      Click here

    3. Remove the front wheel RH.

      Click here

  3. INSTALL FRONT FENDER LINER RH


    1. Install the front fender liner RH with the 11 screws and 13 clips.

      B006FMQC01
      B006AHR clip B006EC9 screw

  4. INSTALL FRONT FENDER WHEEL OPENING MOULDING RH


    1. B006F4B

      Attach the 3 claws to install the front fender wheel opening moulding RH.

  5. INSTALL ENGINE SIDE COVER RH


    1. B006G9U

      Attach the claw.

    2. Install the engine side cover RH with the 4 clips.

  6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  7. INSTALL TRANSMISSION UNDER COVER

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  9. INSTALL FRONT WHEEL RH

    Click here

  10. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height.

      Click here

  11. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

  12. CHECK HEIGHT CHANGE OPERATION

    Click here