FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

   1. 

      Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

   2. Fully tighten the bolt<A> first, then the bolt<B>.

      42 N*m

      428 kgf*cm

      31 ft.*lbf

2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY

   Click here

3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

   1. 

      Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.

   2. Fully tighten the 2 bolts.

      Bolt <A>

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

      Bolt <B>

      42 N*m

      428 kgf*cm

      31 ft.*lbf

   3. 

      *a	Locking Button
      *b	Lock

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note:

      Securely lock the locking button.

   4. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      42 N*m

      428 kgf*cm

      31 ft.*lbf

4. INSTALL CENTER PILLAR GARNISH ASSEMBLY

   Click here

5. INSTALL CENTER PILLAR LOWER GARNISH

   Click here

6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

   1. Install the floor anchor of the front seat outer belt assembly with the bolt.

      42 N*m

      428 kgf*cm

      31 ft.*lbf

   2. Check if the ELR locks.

      Note:

      The check should be performed with the front seat outer belt assembly installed.

      1. With the front seat outer belt assembly installed, check that the belt locks when it is pulled out quickly.

7. INSTALL LAP BELT OUTER ANCHOR COVER

   1. Engage the 3 claws to install the lap belt outer anchor cover.

8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

   for LH Side:Click here

   for RH Side:Click here

9. INSTALL REAR DOOR SCUFF PLATE

   Click here

10. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    for LH Side:Click here

    for RH Side:Click here

11. INSTALL FRONT DOOR SCUFF PLATE

    Click here

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

13. INSPECT SRS WARNING LIGHT

    Click here