CRUISE CONTROL SYSTEM(except 1ND-TV, 8NR-FTS) Cruise SET Indicator Light Circuit

DTC Code DTC Name
Cruise SET Indicator Light Circuit

DESCRIPTION

  • The ECM turns on the SET indicator by sending indicator output demand signals to the combination meter assembly using CAN communication.

  • The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed.

  • The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

PROCEDURE

  1. PERFORM ACTIVE TEST USING GTS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Check the cruise control SET indicator by performing the Active Test.

      Body Electrical > Combination Meter > Active Test

      Tester Display

      Measurement Item

      Control Range

      Diagnostic Note

      Indicat. SET

      Cruise control SET indicator

      ON / OFF

      -

      Body Electrical > Combination Meter > Active Test

      Tester Display

      Indicat. SET

      OK

      The cruise control SET indicator goes on or goes off.

    Result

    Proceed to

    OK

    NG
    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Click here

    NG

    REPLACE COMBINATION METER ASSEMBLY

    Click here