INTAKE SYSTEM ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT INTAKE SYSTEM


    1. Check that there is no air suction at the points shown in the illustration.

      A004ID4E02
      A004JE4E01
      Text in Illustration
      *A for Manual Transmission (Aluminum Intake Manifold) *B for Manual Transmission (Resin Intake Manifold)
      *C for Automatic Transmission - -
      A004I9S Check points A004KUZ Forward

      Note

      Disengagement, cracks or damage in the intake component may cause an idling defect.

  2. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. A004HFY

      Disengage the 2 clips.

    2. A004H0D

      Lift the rear air cleaner case, and disengage the 2 claws.

    3. A004KHW

      Lift the rear air cleaner case as shown in the illustration, and remove the air cleaner filter element sub-assembly.

    4. Check that the air cleaner element is moderately clean.

      Standard air cleaner element condition
      Not too dirty.

      Note

      If the element is too dirty, replace the air cleaner filter element.

    5. Use compressed air if the air cleaner filter element needs to be cleaned.

    6. Lift the rear air cleaner case, and install the air cleaner filter element sub-assembly.

    7. Engage the 2 claws.

    8. A004ICLE02
      Text in Illustration
      *1 Locating Lugs

      Engage the 2 clips.

      Note


      • Securely engage the lower side claws of the air cleaner case.

      • Check if the right and left locating lugs of the air cleaner case do not get into the opposite air cleaner case.