REFRIGERANT LINE REMOVAL

PROCEDURE


  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    Click here

  2. REMOVE PIPING CLAMP (for DENSO Made)


    1. for Suction Hose Sub-assembly:


      1. While pressing the end of the suction hose sub-assembly into the end of the suction pipe sub-assembly, use pliers to squeeze together both sides of the piping clamp until it breaks apart.

        A001Y5EC01
        *1 Suction Pipe Sub-assembly *2 Suction Hose Sub-assembly
        *3 Piping Clamp - -
        *a Press In - -

        Note


        • If any foreign matter is adhered to the connecting part, brush it off or use compressed air to remove it.

        • Make sure that fragments of the piping clamp do not enter the piping.

      2. Disconnect the suction hose sub-assembly.

        Note

        Clean off any foreign matter near the ends of the suction hose sub-assembly and suction pipe sub-assembly.

      3. Remove the 2 O-rings from the suction hose sub-assembly.

        Note

        Wrap the open ends of the separated suction pipe sub-assembly and suction hose sub-assembly with vinyl tape to prevent entry of moisture and foreign matter.

      4. Remove the piping clamp.

    2. for Cooler Refrigerant Liquid Pipe A:

      Click here