SIMPLE INTELLIGENT PARKING ASSIST SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a steering angle sensor internal malfunction signal from the spiral cable with sensor sub-assembly via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1626

Steering Angle Sensor Failure

A malfunction signal is transmitted from the spiral cable with sensor sub-assembly

  • Spiral cable with sensor sub-assembly

  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

Note:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Initialization.

Click here

PROCEDURE

  1. REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    1. Replace the spiral cable with sensor sub-assembly.

      Click hereClick here

    Result

    Proceed to

    NEXT
    NEXT

  2. CHECK DTC OUTPUT

    1. Clear the DTCs.

      Click here

      Body Electrical > Clearance Sonar / Simple-IPA. > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.

      Body Electrical > Clearance Sonar / Simple-IPA. > Trouble Codes

      OK

      No DTCs are output.

    Result

    Proceed to

    OK

    NG
    OK

    END (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY WAS DEFECTIVE)

    NG

    REPLACE CLEARANCE WARNING ECU ASSEMBLY

    for Hatchback LHD, Wagon LHD:Click here

    for Hatchback RHD, Wagon RHD:Click here

    for Sedan:Click hereClick here