REAR DOOR SPEAKER REMOVAL

PROCEDURE


  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  2. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  3. REMOVE REAR DOOR ARMREST COVER

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  5. REMOVE REAR SPEAKER ASSEMBLY


    1. A005C6C

      Disconnect the connector.

    2. Using a drill bit with a diameter of less than 4 mm (0.158 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

  6. REMOVE REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    1. A005D4T

      Disengage the clamp.

    2. Remove the 2 screws and rear No. 2 speaker assembly.