OIL PUMP ASSEMBLY(for 8NR-FTS) REMOVAL

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click hereClick hereClick hereClick here

  2. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click hereClick here

  3. REMOVE FRONT ENGINE MOUNTING INSULATOR

    1. A350166

      Remove the bolt and nut, and separate the front engine mounting insulator from the front engine mounting bracket.

    2. A350167

      Remove the 2 bolts and front engine mounting insulator from the front crossmember sub-assembly.

  4. REMOVE FRONT ENGINE MOUNTING BRACKET

    Click here

  5. REMOVE OIL PUMP WITH MOTOR ASSEMBLY

    1. A283665

      Disconnect the oil pump with motor assembly connector.

    2. Remove the bolt and disconnect the wire harness from the oil pump with motor assembly.

    3. A350168

      Remove the 3 bolts and oil pump with motor assembly from the continuously variable transaxle assembly.

      Note:

      The O-ring of the oil pump with motor assembly is not available as a supply part. As the O-ring is a non-reusable part, if the oil pump with motor assembly is removed, the oil pump with motor assembly must be replaced with a new one.