SHIFT LEVER DISASSEMBLY

PROCEDURE


  1. REMOVE FLOOR SHIFT SHIFT LEVER HOUSING


    1. A004J6B

      Using a screw driver, disengage the claw and disconnect the connector.

    2. A004HSS

      Using a thin-bladed screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.

    3. A004J3I

      Using a thin-bladed screwdriver, pull out terminals 2, 3, 10 and 11 of the transmission control switch connector.

    4. A004JLO

      Remove the shift lever lock nut and shift lever lock pin.

    5. A004HEB

      Disengage the 2 claws and remove the floor shift shift lever housing from the base plate.

  2. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

    A004HH9

    1. Remove the pin then remove the shift lock release arm and shift lock control unit assembly.

    2. Remove the shift lock release arm from the shift lock control unit assembly.

  3. REMOVE DETENT ROD

    A004HE6

    1. Remove the detent lock clamp.

    2. Remove the detent lock spring and detent lock rod.

    3. Remove the cushion detent lock from the detent lock rod.

    4. Remove the bush detent lock.

  4. REMOVE SHIFT LEVER PLATE GROMMET


    1. A004HVG

      Remove the shift lever plate grommet from the base plate.

  5. REMOVE FLOOR SHIFT CONTROL SHAFT LEVER


    1. A004HV0

      Using a pin punch (3 mm (0.118 in.)) and a hammer, drive out the spring pin.

    2. A004I0L

      Remove the floor shift control shaft lever from the base plate.

  6. REMOVE FLOOR SHIFT CONTROL SELECT LEVER


    1. A004I1L

      Remove the floor shift support bracket and the floor shift control shaft lever from the base plate.

  7. REMOVE FLOOR SHIFT SUPPORT BRACKET


    1. A004IRJ

      Remove the floor shift support bracket from the floor shift control shaft lever.

    2. A004JXJ

      Remove the pin and the spring from the floor shift support bracket.

  8. REMOVE SHIFT LEVER SEAT SUB-ASSEMBLY


    1. A004J0Z

      Remove the 4 spacer plates and shift lever seat sub-assembly from the base plate.

  9. REMOVE FLOOR SHIFT CONNECTING ROD SWIVEL


    1. A004KT0

      Remove the clip, 2 washers, grommet, pin and floor shift connecting rod swivel from the select lever.