THERMOSTAT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking Assist Monitor System

Click here

Panoramic View Monitor System

Click here

Note

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE GENERATOR ASSEMBLY

    Click here

  3. DISCONNECT NO. 2 RADIATOR HOSE

    Click here

  4. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY


    1. B0086VQ

      Disconnect the water inlet with thermostat sub-assembly connector.

    2. B0083UJ

      Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

      Note


      • Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

      • Do not damage the water inlet with thermostat sub-assembly.

      Tech Tips

      When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.

    3. B00858X

      Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.

    4. B0085E5

      Remove the gasket from the water inlet with thermostat sub-assembly.