SFI SYSTEM PRECAUTION


  1. WHEN USING GTS

    CAUTION:


    • Strictly obey all traffic rules and regulations.

    • Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

    • B008KGE

      Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.

    • B008MIS

      Do not operate the GTS while driving the vehicle.

    • Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.

  2. INITIALIZATION

    Note


    • Perform Registration (VIN registration or frame number registration) when replacing the ECM.

      Click here

    • Before replacing the ECM, refer to Service Bulletin (for Immobiliser System).

    • Make sure to perform Reset Memory (CVT initialization), deceleration sensor zero point calibration and CVT oil pressure calibration when replacing the ECM or the oil pressure sensor.

      Click here

    • When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

      Click here

  3. IGNITION SWITCH EXPRESSIONS

    Tech Tips

    The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression Ignition Switch (Position) Engine Switch (Condition)
    Ignition Switch off LOCK Off (Lock)
    Ignition Switch ACC ACC On (ACC)
    Ignition Switch ON ON On (IG)
    Engine Start START On (Start)

  4. PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY

    When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.