STEERING ANGLE SENSOR REMOVAL

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  3. INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Click here

  4. REMOVE LOWER STEERING COLUMN COVER


    1. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

    2. for Power Tilt and Power Telescopic Steering Column:

      Click here

  5. REMOVE UPPER STEERING COLUMN COVER


    1. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

    2. for Power Tilt and Power Telescopic Steering Column:

      Click here

  6. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).

    • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the engine switch on (IG).

    • When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.


    1. Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.

      B005AP8C01
      *A w/ Steering Heater *B w/o Steering Heater

    2. Disconnect each connector from the spiral with sensor cable sub-assembly.

    3. B0059LM

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.