PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:U0100, U0125, U0126, U0129, U0142

DTC Code DTC Name
U0100 Lost Communication with ECM / PCM "A"
U0125 Lost Communication with Yaw Rate Sensor Module
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module
U0142 Lost Communication with Body Control Module "B"

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle. Based on this information, the driving support ECU assembly sends pre-crash safety control operation signals. These DTCs are stored when a communication malfunction occurs between the sensors and ECUs that detect crashes, or between ECUs that perform the pre-crash safety control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When the engine switch is on (IG), a communication error between the ECM and the driving support ECU assembly is detected for approximately 5 seconds.

  • CAN communication system

  • ECM

  • Driving support ECU assembly
U0125 Lost Communication with Yaw Rate Sensor Module When the engine switch is on (IG), a communication error between the airbag ECU assembly (yaw rate sensor) and the driving support ECU assembly is detected for approximately 1 second.

  • CAN communication system

  • Airbag ECU assembly (yaw rate sensor)

  • Driving support ECU assembly
U0126 Lost Communication with Steering Angle Sensor Module When the engine switch is on (IG), a communication error between the spiral with sensor cable sub-assembly (steering angle sensor) and the driving support ECU assembly is detected for approximately 1 second.

  • CAN communication system

  • Spiral with sensor cable sub-assembly

  • Driving support ECU assembly
U0129 Lost Communication with Brake System Control Module When the engine switch is on (IG), a communication error between the brake actuator assembly (skid control ECU) and the driving support ECU assembly is detected for approximately 3 seconds.

  • CAN communication system

  • Brake actuator assembly (skid control ECU)

  • Driving support ECU assembly
U0142 Lost Communication with Body Control Module "B" When the engine switch is on (IG), a communication error between the main body ECU (multiplex network body ECU) and driving support ECU assembly is detected for approximately 11.2 seconds.

  • CAN communication system

  • Main body ECU (multiplex network body ECU)

  • Driving support ECU assembly

PROCEDURE


  1. CHECK FOR DTCs


    1. Clear the DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.

    3. Check the DTCs.

      Click here


      Body Electrical > Pre-Crash 2 > Trouble Codes
      Result
      Result Proceed to
      DTC U0100, U0125, U0126, U0129 and U0142 are not output A
      DTC U0100, U0125, U0126, U0129 or U0142 is output (for LHD) B
      DTC U0100, U0125, U0126, U0129 or U0142 is output (for RHD) C

    A

    USE SIMULATION METHOD TO CHECK Click here

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here