FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart (Click here).

PROCEDURE

  1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH

    B221149

    1. Attach the 6 claws to install the front door belt moulding.

    2. Install the clip.

  2. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  5. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  6. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH

    Click here

  7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  9. INSTALL FRONT DOOR TRIM MOULDING LH

    Click here

  10. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).