WATER PUMP REMOVAL

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click hereClick here

  2. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click hereClick here

  4. DRAIN ENGINE COOLANT

    Click here

  5. REMOVE RADIATOR RESERVOIR ASSEMBLY

    Click hereClick here

  6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  7. REMOVE FAN AND GENERATOR V BELT

    Click here

  8. REMOVE OIL PAN INSULATOR

    Click hereClick here

  9. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

    1. A235368

      Remove the nut.

    2. A231499

      Loosen the 4 bolts and 2 nuts from the front engine mounting insulator and rear engine mounting insulator.

      Tip:

      Loosen the bolts and nuts approximately 10 turns. Do not remove them.

    3. A295980

      Place a wooden block between a jack and the engine.

      Note:

      Make sure to set a jack as shown in the illustration. Do not place the jack on the oil pan sub-assembly.

    4. Jack up the engine slightly.

    5. A235369

      Remove the 5 bolts, nut and engine mounting insulator sub-assembly RH.

      Tip:

      Jacking up the engine slightly makes the engine mounting insulator sub-assembly RH easier to remove.

  10. REMOVE ENGINE MOUNTING SPACER

    1. A295979

      Remove the 2 bolts and engine mounting spacer.

  11. REMOVE IDLER PULLEY COVER PLATE

    Click here

  12. REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY

    Click here

  13. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

    1. A126838

      Remove the pulley bolt, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.

  14. REMOVE ENGINE WATER PUMP ASSEMBLY

    1. A300908

      Remove the 7 bolts, engine water pump assembly and gasket.