DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A52

DTC Code DTC Name
C1A52 Driving Support ECU Communication Abnormal

DESCRIPTION

DTC C1A52 is stored when the hybrid vehicle control ECU cannot recognize the driving support ECU assembly.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A52

Driving Support ECU Communication Abnormal

Approximately 17 seconds after the power switch is turned on (IG), the hybrid vehicle control ECU cannot recognize the driving support ECU assembly for approximately 1.3 seconds or more.

  • Hybrid vehicle control ECU

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note:

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

PROCEDURE

  1. CHECK FOR DTCs

    1. Clear the DTCs.

      Click here

      Powertrain > Radar Cruise2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

      1. Turn the power switch on (IG).

      2. Wait for 20 seconds or more.

    3. Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.

    4. Check for DTCs.

      Click here

      Powertrain > Radar Cruise2 > Trouble Codes

      Result

      Result

      Proceed to

      DTC C1A52 is output

      A

      DTC C1A52 is not output

      B
    B

    USE SIMULATION METHOD TO CHECK

    Click hereClick hereClick here

    A

  2. REPLACE HYBRID VEHICLE CONTROL ECU

    1. Replace the hybrid vehicle control ECU.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK FOR DTCs

    1. Clear the DTCs.

      Click here

      Powertrain > Radar Cruise2 > Clear DTCs

    2. Make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

      1. Turn the power switch on (IG).

      2. Wait for 20 seconds or more.

    3. Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.

    4. Check for DTCs.

      Click here

      Powertrain > Radar Cruise2 > Trouble Codes

      Result

      Result

      Proceed to

      DTC C1A52 is output

      A

      DTC C1A52 is not output

      B
    A

    REPLACE DRIVING SUPPORT ECU ASSEMBLY

    B

    END (HYBRID VEHICLE CONTROL ECU WAS DEFECTIVE)