COMBUSTION TYPE POWER HEATER SYSTEM, Diagnostic DTC:050

DTC Code DTC Name
050 Detection of No Ignition

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

050

Detection of No Ignition

The ECU is locked as a result of 10 successive heater ignition failures.

  • Intake air duct

  • No. 2 exhaust pipe sub-assembly

  • Fuel pump filter

  • Heater pump assembly

  • Heater assembly

CAUTION / NOTICE / HINT

Tip:

Clear the DTCs by pressing the memory clear buttons on the DTC tester to unlock the ECU.

PROCEDURE

  1. INSPECT INTAKE AIR DUCT

    1. Inspect the intake air duct.

      Result

      Result

      Proceed to

      There is no problem with the intake air duct.

      A

      The intake air duct is clogged, or other problems are found.

      B
    B

    CLEAN OR REPLACE INTAKE AIR DUCT

    A

  2. INSPECT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

    1. Inspect the No. 2 exhaust pipe sub-assembly.

      Result

      Result

      Proceed to

      There is no problem with the No. 2 exhaust pipe sub-assembly.

      A

      The No. 2 exhaust pipe sub-assembly is clogged, or other problems are found.

      B
    B

    CLEAN OR REPLACE NO. 2 EXHAUST PIPE SUB-ASSEMBLY

    A

  3. INSPECT HEATER PUMP ASSEMBLY

    1. E124460C01

      *a

      Component without harness connected

      (Heater Pump Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      1 - 2

      Always

      9 to 12 Ω

    2. Inspect heater pump assembly operation.

      1. Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2, and check the pressure of the hose by hand.

        Note:

        This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.

        OK

        Pressure is applied to the hose.

    Result

    Proceed to

    OK

    NG
    NG

    REPLACE HEATER PUMP ASSEMBLY

    Click hereClick here

    OK

  4. REPLACE FUEL FILTER ASSEMBLY

    1. Replace the fuel filter assembly with a new one and check that the condition returns to normal.

      for 1AD-FTV:Click here

      for 1ND-TV:Click here

      OK

      The heater ignites normally and starts operating.

    Result

    Proceed to

    OK

    NG
    OK

    END

    NG

    REPLACE HEATER ASSEMBLY

    Click hereClick here