RELAY ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSPECT LIGHT CUT RELAY


    1. Remove the lower instrument panel sub-assembly.

      Click here

    2. B00258F

      Remove the light cut relay.

    3. B002901N01

      Check the resistance.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
        Battery voltage applied to terminals 1 and 2 Below 1 Ω

        If the result is not as specified, replace the light cut relay.

    4. B00258F

      Install the light cut relay.

    5. Install the lower instrument panel sub-assembly.

      Click here