CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.
INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
Note
The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the rear power window regulator motor assembly with the 3 screws.
Tech Tips
A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
INSTALL REAR DOOR POWER WINDOW REGULATOR ASSEMBLY
INSTALL REAR DOOR GLASS SUB-ASSEMBLY
INSTALL REAR DOOR REAR GUIDE SEAL
INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY
CONNECT REAR DOOR WEATHERSTRIP
Install the upper part of rear door weatherstrip.
INSTALL REAR DOOR GLASS RUN
INSTALL REAR DOOR SERVICE HOLE COVER
INSTALL REAR DOOR TRIM BRACKET
INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)
INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
INSTALL REAR DOOR ARMREST COVER
INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL DECK FLOOR BOX RH
INSTALL REAR DECK FLOOR BOX
INSTALL NO. 1 DECK BOARD
INSTALL NO. 2 DECK BOARD
INSTALL DECK BOARD ASSEMBLY
INITIALIZE POWER WINDOW CONTROL SYSTEM
INSPECT POWER WINDOW OPERATION