LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the luggage compartment door outside garnish removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedure Effects / Inoperative when not Performed Link
When the luggage compartment door is opened using a mechanical key Initialize luggage closer motor assembly The power trunk lid does not operate

Click here

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT DOOR ASSIST GRIP

    Click here

  2. REMOVE SWITCH BEZEL

    Click here

  3. REMOVE NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  4. REMOVE LUGGAGE COMPARTMENT DOOR COVER

    Click here

  5. REMOVE REAR LIGHT ASSEMBLY LH

    Click here

  6. REMOVE REAR LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  7. REMOVE UPPER LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH LH


    1. B006FEZC02
      B006GBM Protective Tape

      Put protective tape around the upper luggage compartment door outside garnish LH.

    2. Using a moulding remover, detach the claw and remove the upper luggage compartment door outside garnish LH.

  8. REMOVE UPPER LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH RH

    Tech Tips

    Use the same procedure described for the LH side.

  9. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. B006FXO

      Remove the 4 screws.

    2. B006FG6C02
      B006BJ7 Place Hands Here
      B006DHE Remove in this Direction
      B006GBM Protective Tape

      Put protective tape around the luggage compartment door outside garnish sub-assembly.

    3. Detach the clip and remove the luggage compartment door outside garnish sub-assembly as shown in the illustration.