WIDE VIEW FRONT MONITOR SYSTEM

CAUTION / NOTICE / HINT

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result

   Proceed to
   NEXT

   NEXT

2. INSPECT BATTERY VOLTAGE

   1. Measure the battery voltage with the engine switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

      Result

      Proceed to
      NEXT

   NEXT

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

   1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B

   GO TO CAN COMMUNICATION SYSTEM

   Click here

   A

4. CHECK DTC OUTPUT*

   1. Check for DTCs.

      Click here

   2. Clear the DTCs.

      Click here

   3. Check for DTCs.

      Click here

      Result

      Result	Proceed to
      No DTC is output	A
      DTC is output	B

   B

   GO TO DIAGNOSTIC TROUBLE CODE CHART

   Click here

   A

5. PROBLEM SYMPTOMS TABLE

   1. Refer to the Problem Symptoms Table.

      Click here

      Result

      Result	Proceed to
      Fault is not listed in problem symptoms table	A
      Fault is listed in problem symptoms table	B

   B

   ADJUST, REPAIR OR REPLACEClick here

   A

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

   1. Terminals of ECU.

      Click here

      Result

      Proceed to
      NEXT

   NEXT

7. ADJUST, REPAIR OR REPLACE

   Result

   Proceed to
   NEXT

   NEXT

8. CONFIRMATION TEST

   Result

   Proceed to
   NEXT

   NEXT

   END