TRANSMISSION CONTROL CABLE REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  3. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

    Click here

  4. REMOVE BATTERY

    Click hereClick hereClick here

  5. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click hereClick hereClick here

  6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click hereClick hereClick here

  7. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR

    1. C299040

      Remove the 3 nuts and front No. 1 floor heat insulator from the vehicle body.

  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    1. C299037

      Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.

    2. C299038N01

      Remove the clip (A) and disconnect the transmission control shift cable from the manual transaxle assembly.

    3. Remove the clip (B) and disconnect the transmission control shift cable from the floor shift control lever housing support bracket.

    4. C299039N01

      Remove the clip (A) and disconnect the transmission control select cable from the manual transaxle assembly.

    5. Remove the clip (B) and disconnect the transmission control select cable from the floor shift control lever housing support bracket.

    6. C299041

      Remove the 3 nuts and transmission control cable assembly from the vehicle exterior.