SHIFT AND SELECT LEVER SHAFT REASSEMBLY

PROCEDURE

  1. INSTALL CONTROL SHAFT COVER OIL SEAL

    1. C112481E02

      Using SST and a hammer, install a new control shaft cover oil seal to the control shaft cover.

      09307-12010

      Standard depth

      0 to 0.5 mm (0 to 0.0196 in.)

    2. Coat the lip of the control shaft cover oil seal with MP grease.

  2. INSTALL SHIFT LEVER DAMPER

    1. Clean the threads of the bolt and shift lever damper hole.

    2. C344261

      Apply a few drops of adhesive to 2 or 3 threads of the 2 bolts.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    3. Install the shift lever damper to the shift and select lever shaft with the 2 bolts.

      18.6 N*m

      190 kgf*cm

      14 ft.*lbf

  3. INSTALL PIN

    1. C284641C01

      *a

      Standard depth

      Install the 2 pins to the inner No. 1 shift lever.

      Standard depth

      3.5 to 4.5 mm (0.138 to 0.177 in.)

  4. INSTALL SHIFT GATE PLATE

    1. C277884

      Install the shift gate plate with the 2 bolts.

      8.5 N*m

      87 kgf*cm

      75 in.*lbf

  5. INSTALL SHIFT AND SELECT LEVER SHAFT

    1. Coat the shift and select lever boot lip with MP grease.

    2. C344262C01

      *1

      Control Shaft Cover

      *2

      Shift and Select Lever Boot

      *3

      Shift and Select Lever Shaft

      Install the shift and select lever boot and control shaft cover to the select lever shaft.

  6. INSTALL INNER NO. 1 SHIFT LEVER

    1. C344260

      Install the inner No. 1 shift lever and shift interlock plate to the shift and select lever shaft.

    2. C344263

      Using a 5 mm pin punch and hammer, tap a new slotted spring pin into the inner No. 1 shift lever.

      Standard depth

      0.4 to 1.4 mm (0.0158 to 0.0551 in.)