OUTER REAR VIEW MIRROR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during outer rear view mirror assembly with cover removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Side television camera assembly LH

  • Outer rear view mirror assembly LH

  • Side television camera assembly RH

  • Outer rear view mirror assembly RH

 Side television camera view adjustment Panoramic view monitor system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  2. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY

    Click here

  3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  5. REMOVE FRONT ARMREST ASSEMBLY

    Click here

  6. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  8. REMOVE HOLE PLUG


    1. B00869T

      Remove the hole plug.

  9. REMOVE OUTER MIRROR INSTALL HOLE COVER


    1. B0087TU

      Disconnect the connector.

    2. Disengage the clamp.

    3. B0089GU

      Remove the screw.

    4. Disengage the clip and 2 claws to remove the outer mirror install hole cover.

  10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER


    1. B00876CC01
      *a Clamp
      *b Guide

      Disengage the clamp.

    2. Remove the 3 nuts.

    3. Disengage the claw and 2 guides and remove the outer rear view mirror assembly with cover.