PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEIGHT CONTROL PRESSURE SENSOR


    1. B0069J9

      Apply a light coat of lithium soap base glycol grease to a new O-ring.

    2. Install the O-ring to the height control pressure sensor.

    3. Install the height control pressure sensor to the pneumatic tank with tube assembly.

      Torque:
      10.8 N*m  { 110 kgf*cm, 8 ft.*lbf }
    4. B006G7O

      Connect the connector.

  2. AIR CHARGING

    Click here

    Tech Tips


    • Make sure to use the nitrogen gas injector (SST) and adapter (SST).

    • Select an adapter (SST) that matches the standard of the nitrogen cylinder and install it.

    • The adapter (SST) is not required for JIS standard.

    SST
    09761-50010
    09761-05040

  3. CHECK CONNECTIONS OF TUBES FOR AIR LEAKAGE

    Click here

  4. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  5. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height.

      Click here

  6. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

  7. CHECK HEIGHT CHANGE OPERATION

    Click here