SIDE AIRBAG SENSOR(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

      B296256C01

      *a

      Correct

      *b

      Incorrect

    4. Insert the side airbag sensor assembly pin (stopper) into the body hole and install the side airbag sensor assembly to the vehicle body with the bolt.

      9.0 N*m

      92 kgf*cm

      80 in.*lbf

      Note:

      • If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the side airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the side airbag sensor assembly pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the side airbag sensor assembly because the side airbag sensor assembly pin (stopper) is easily damaged.

    5. Connect the connector to the side airbag sensor assembly.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      1. Be sure to engage the connector until it is locked (when locking, make sure that a click sound can be heard).

        C198070C15

        *a

        White Housing Lock

        *b

        Engage
        Tip:

        When engaged, the white housing lock will slide. Be sure not to hold the white housing lock or part (A), as it may result in an insecure fit.

    6. Check that there is no looseness in the installed parts of the side airbag sensor assembly.

  2. INSTALL LOWER CENTER PILLAR GARNISH

    Click here

  3. INSTALL REAR SEAT SIDE GARNISH

    Click here

  4. CONNECT NO. 1 REAR SEAT OUTER BELT ASSEMBLY

    Click here

  5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. INSPECT SRS WARNING LIGHT

    Click hereClick here