AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System), Diagnostic DTC:B1412

DTC Code DTC Name
B1412 Ambient Temperature Sensor Circuit

DESCRIPTION

The thermistor assembly is installed in front of the cooler condenser assembly to detect the ambient temperature, which is used to control the air conditioning system. This sensor is connected to the air conditioning amplifier assembly and detects fluctuations in the ambient temperature. This data is used for controlling the cabin temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the thermistor assembly changes in accordance with the ambient temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the thermistor assembly and reads voltage changes due to changes in the resistance of the thermistor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1412 Ambient Temperature Sensor Circuit Open or short in ambient temperature sensor circuit

  • Thermistor assembly

  • Air conditioning amplifier assembly

  • Harness or connector

Memorized

(4 sec. or more)*

Tech Tips

If the ambient temperature is approximately -52.9°C (-63.22°F) or lower, DTC B1412 may be stored even though the system is normal.

WIRING DIAGRAM

B0086HFE06
*a Thermistor Assembly
*b Air Conditioning Amplifier Assembly

PROCEDURE


  1. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Air Conditioner / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Air Conditioner > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Ambient Temp Sensor Thermistor assembly

      Min.: -23.30°C (-9.94°F)

      Max.: 65.95°C (150.71°F)

      		 Actual ambient temperature displayed

      Thermistor assembly circuit malfunction


      • When open circuit: -23.30°C (-9.94°F)

      • When short circuit: 65.95°C (150.71°F)

      Body Electrical > Air Conditioner > Data List
      Tester Display
      Ambient Temp Sensor
      OK
      The display is as specified in the normal condition column.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Click here

    NG

  2. INSPECT THERMISTOR ASSEMBLY


    1. Remove the thermistor assembly.

      Click here

    2. Inspect the thermistor assembly.

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE THERMISTOR ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (THERMISTOR ASSEMBLY - AIR CONDITIONING AMPLIFIER ASSEMBLY)


    1. Disconnect the K55 air conditioning amplifier assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A17-2 - K55-13 (TAM) Always Below 1 Ω
      A17-1 - K55-2 (SG-2) Always Below 1 Ω
      A17-2 or K55-13 (TAM) - Other terminals and body ground Always 10 kΩ or higher
      A17-1 or K55-2 (SG-2) - Other terminals and body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR